Microscan QX-830 - Page 315

QX-830 Compact Industrial Scanner User’s Manual A-27
Appendices
Ambles to Source
Echo to Source
Output at End of Read Cycle
Output at ETX
Output at Timeout
Array Communication Modes
Mode
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: CR (0x0D)
Options: Any 7-bit ASCII character
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: 200 (x10 ms = 2 seconds)
Options: 0 – 65535
Serial Cmd: <K162,mode,source,daisy chain i.d. status,daisy chain i.d.>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Daisy Chain