A-56 QX-830 Compact Industrial Scanner User’s Manual
Serial Commands
EZ Button
Global Status
Default on Power-On
EZ Button Modes
Auto Framing Options
Laser Status
Serial Cmd: <K770,global status,default on power-on>
Default: 1 = Enabled
Options: 0 = Disabled
1 = Enabled
2 = Trigger
3 = Unlatch Outputs
4 = Parameter Switch
Serial Cmd: <K770,global status,default on power-on>
Default: 1 = Enabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K771,single beep,two beeps,three beeps,four beeps>
Options: 0 = Disabled 1 = Enabled
Single Beep Two Beeps Three Beeps Four Beeps
0 = Disabled 0 = Disabled 0 = Disabled 0 = Disabled
1 = Read Rate 1 = Read Rate 1 = Read Rate 1 = Read Rate
2 = Auto Calibration 2 = Auto Calibration 2 = Auto Calibration 2 = Auto Calibration
3 = Save for Power-On 3 = Save for Power-On
3 = Save for Power-On
3 = Save for Power-On
4 = Auto Framing 4 = Auto Framing 4 = Auto Framing 4 = Auto Framing
5 = Load New Master 5 = Load New Master 5 = Load New Master 5 = Load New Master
6 = Sleep Mode 6 = Sleep Mode 6 = Sleep Mode 6 = Sleep Mode
7 = Unused 7 = Unused 7 = Unused 7 = Unused
8 = Unused 8 = Unused 8 = Unused 8 = Unused
9 = Bar Code Config. 9 = Bar Code Config. 9 = Bar Code Config. 9 = Bar Code Config.
Serial Cmd: <K773,unused,laser status>
Default: 1 = Enabled
Options: 0 = Disabled 1 = Enabled
To Next Page
Loading...