MIMAKI JV34-260 - Page 174

6-12
Message Cause Solution
The set position of the media is not
proper. The media detection has not
completed.
Set the media to the proper position
again. ( P.2-9, P.2-20, P.2-26)
Y-origin could not be detected.
Turn off the main power to the
machine and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
An abnormality occurs in the control
system of the heavy-duty take-up
device.
An abnormality occurs in the control
system of the heavy-duty feeding
device.
An abnormality occurs in the control
system of the heavy-duty take-up
device.
If the error message is displayed even
if you set the medium properly, once
turn OFF the power supply and after a
while, turn it ON again.
If the error message is displayed
again, contact our service and sales
office.
An abnormality occurs in the control
system of the heavy-duty feeding
device.
An abnormality occurs in the heavy-
duty take-up device.
Confirm the connection of the heavy-
duty take-up device.
If the error message is displayed even
if you connect the device properly,
once turn OFF the power supply and
after a while, turn it ON again.
If the error message is displayed
again, contact our service and sales
office.
The heavy-duty take-up device is
not connected.
Turn off the main power to the
machine and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
The heavy-duty take-up device is
connected to a wrong position.
An abnormality occurs in the heavy-
duty take-up device.
An abnormality occurs in the heavy-
duty feeding device.
Confirm the connection of the heavy-
duty feeding device.
If the error message is displayed even
if you connect the device properly,
once turn OFF the power supply and
after a while, turn it ON again.
If the error message is displayed
again, contact our service and sales
office.
The heavy-duty feeding device is
not connected.
Once turn OFF the power supply and
after a while, turn it ON again.
If the error message is displayed
again, contact our service and sales
office.
The heavy-duty feeding device is
connected to a wrong position.
***** ERROR 50 *****
MED I A DE T ECT
***** ERROR 51 *****
Y-ORIGIN
***** ERROR 64 *****
TAKE - UP VOLTAGE
***** ERROR 64 *****
FEEDER VOLTAGE
***** ERROR 65 *****
TAKE - UP TENS I ON - BAR
***** ERROR 66 *****
FEEDER TENS I ON - BAR
***** ERROR 67 *****
TAKE - UP UN I T 0 0
***** ERROR 67 *****
TAKE - UP UN I T 0 1
***** ERROR 67 *****
TAKE - UP UN I T 0 2
***** ERROR 67 *****
TAKE - UP UN I T 0 4
***** ERROR 67 *****
FEEDER UN I T 0 0
***** ERROR 67 *****
FEEDER UN I T 0 1
***** ERROR 67 *****
FEEDER UN I T 0 2