MIMAKI UCJV300 Series - Mist Filter Replacement Procedure and Print Head Nozzle Washing

Chapter 6 Maintenance
139
3
Open the maintenance covers.
4
Remove the mist filter.
• To remove the mist filter, pull the knob to the front while pushing the hook in the direction indicated
by the arrow.
Claw
Handle
Handle
Claw
5
Clean the filter.
• Remove the filter and press it down with a paper towel to remove dirt.
• Wipe off the dirt adhering to the filter case.
• Replace the mist filter if it gets very dirty—for example, due to liquefaction of ink adhering
to the filter.
"Mist Filter Replacement"(P. 149)
6
Return the mist filter to its original position.
7
Close the maintenance covers, then press the [ENTER] key.
Print Head Nozzle Washing
If print defects (e.g., nozzle clogging, deflection) remain unresolved even after head cleaning ( "Head
Cleaning"(P. 70)), apply nozzle washing to the print head.
6