MIMAKI UCJV300 Series - Completing Cap Absorber Replacement and Mist Filter Replacement Procedure

Chapter 6 Maintenance
149
9
Once replacement is complete, close the front cover, then turn on the power.
• Check to confirm that the carriage returns to the station.
Mist Filter Replacement
Check the mist filter. Replace if very dirty.
1
In LOCAL mode, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Head Maint.], then press the [ENTER] key.
• The carriage moves to the maintenance space.
3
Open the maintenance cover.
4
Remove the mist filter BOX.
• Push the claw in the direction indicated by the arrow and slide to the side to remove.
Claw
Handle
Handle
Claw
5
Replace the mist filter with a new one.
6
Insert the mist filter BOX.
• Insert until it clicks into place. Confirm that the claw is engaged.
7
Press the [ENTER] key once replacement is completed.
8
Close the maintenance covers, then press the [ENTER] key.
6