MIMAKI UCJV300 Series - Completing Nozzle Washing, Ink Discharge Channel Cleaning, and Media Sensor Cleaning

Chapter 6 Maintenance
141
Ink Discharge Channel Cleaning
Clean the ink discharge channel regularly to prevent clogging of the ink discharge channel below the cap.
1
In LOCAL mode, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [DISWAY WASH], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the front cover.
4
Fill the cap with washing liquid.
• Use a syringe to draw up some washing liquid and fill until it almost overflows from the cap.
5
Press the [ENTER] key.
• The pump tube (ink discharge channel below the cap) is washed. “Please wait” appears on the
display.
• Pump tube washing takes approximately one minute.
6
Close the front cover, then press the [ENTER] key.
Media Sensor Cleaning
Media sensors are located on the rear cover and carriage underside. The media cannot be detected
correctly if dust or debris accumulates on the sensors. Remove any debris using cotton swabs or a soft cloth.
Rear of product Carriage underside
6