MIMAKI UCJV300 Series - Changing the Print Origin and Starting Printing

Chapter 2 Printing
76
Changing the Origin
The print start position can be altered. Use the LED pointer to set the origin.
• Print origin default value
– Feed (longitudinal, X’) direction: Approx. 75 mm to rear from platen cutting slot
– Scan (lateral, Y’) direction: 15 mm from right edge of media
Cutting slot
Approx. 75 mm (X')
15 mm (Y')
1
In LOCAL mode, press .
• The Origin Setup screen appears.
X
0.0
Y
0.0
SETORIGIN
2
Press to move the origin to the desired position.
• The carriage moves left and right and feeds the medium.
3
Press the [ENTER] key.
• The origin is updated.
Starting Printing
1
Press [REMOTE].
• The machine switches to REMOTE mode and is ready for printing.
2
Send the RIP data from the PC.
• "Preparing RIP Data"(P. 74)
3
Start printing.
• Printing starts once RIP data is received.
0.0m
600x600 16p / Bi / Hi / Vd
PRINT
REMORT
Resolution
Number of passes
Scan direction (Uni: unidirectional, Bi: bidirectional)
Scan speed (Std: standard, Hi: high speed)
Dot type
VD: Variable dot
ND: Normal dot
Length of medium printed