Chapter 3 Cutting
93
3
Cutting starts.
• Cutting starts once the cutting data is received.
• The remaining amount of data is displayed on the display.
• If the media moves out of place during cutting, immediately turn off the power. Continuing to cut
while the media is not in place may damage the machine.
Pausing Cutting
1
Press [LOCAL] while cutting is in progress.
• Cutting is paused.
• If data is being sent from a PC, data transmission is paused at the PC.
2
Press [REMOTE].
• Cutting resumes.
• No other functions can be used while printing is paused.
Stopping Cutting (Data Clear)
1
In LOCAL mode screen, select [DATA CLEAR].
width:1340mm
DATA CLEARADJUST
LOCAL
2
Press the [ENTER] key to clear the received data.
• The receive buffer is not cleared.
Retracting the Cutter Unit
When cutting or printing-with-a-pen is completed, the cutter unit is positioned on the platen. To check the
cutting result or to set new media, retract the cutter unit from the platen.
1
In LOCAL mode screen, select [TEST CUT].
width:1340mm
PRTOOL
TEST CUT
LOCAL
3
To Next Page
Loading...
