Chapter 7 Troubleshooting
167
16
Close the front cover, then press the [ENTER] key.
• Cleaning starts automatically.
• If you select Head 1 and Head 2 simultaneously, follow the instructions on the display to perform
the air purge.
If the light-blocking cover comes off
If the light-blocking cover comes loose, the ink inside the tank may be exposed to light and begin to harden.
If the light-blocking cover comes loose, reattach as follows:
1
Insert the lug on one side of the light-blocking cover into the corresponding hole in the tank.
2
Insert the lug on the other side while pushing in toward the first hole in Step 1.
Cutting Related
Symptom Corrective action
The cut position shifts. This may indicate a problem with the register mark sensor. Perform the
operation used to check the responsiveness of the register mark sensor.
You cannot check the responsiveness of the register mark sensor
manually.
"Adjusting the Position of the Register Mark Sensor"(P. 168)
Cutting is not possible. Cut a sample stored in the machine to identify the cause. Executing a
sample cut will clear any data saved in the receive buffer.
"Investigating the Cause of Cutting Failures"(P. 170)
The print and cut positions are
misaligned.
Use the MIMAKI RIP software (RasterLink) to print a correction pattern.
Check the correction pattern and input correction values manually.
"Adjusting to Correct Misalignment Between Printing and
Cutting"(P. 170)
7
To Next Page
Loading...
