Chapter 7 Troubleshooting
168
Symptom Corrective action
The print and cut positions are
misaligned in the scan
direction.
Print the correction pattern to perform automatic correction.
1. Load media.
– Prepare white media used to print a correction pattern.
2. In LOCAL mode, select [MENU] > [CUTTING], then press the [ENTER] key.
– The Cutting menu is displayed.
3. Select [MAINTENANCE] > [SCALE ADJUST], then press the [ENTER] key.
4. When the confirmation screen is displayed, press the [ENTER] key.
– Print the correction pattern to perform automatic correction.
Adjusting the Position of the Register Mark Sensor
1
Prepare the media on which register marks are printed.
• "Creating Register Marks"(P. 98)
2
In LOCAL mode, select [MENU] > [CUTTING], then press the [ENTER] key.
• The Cutting menu is displayed.
3
Select [MAINTENANCE] > [MARKS SENSOR] > [SENSOR CHK], then press the [ENTER] key.
• The cutting unit moves over the platen.
4
Press to move the LED pointer.
Mark shape
Type 1 Type 2
LED pointer position
1 mm or more
LED pointer position
1 mm or more
5
Register the information corresponding to the printed register mark conditions.
• "Setting Mark Detection Conditions"(P. 103)
• The set register mark conditions are also stored in [CUTTING] > [TP DETECT]. The settings are
retained even when the power is turned off.
To Next Page
Loading...
