MIMAKI UCJV300 Series - Cutting Menu Overview

Chapter 5 Settings
124
5.6 Cutting Menu
You can set various settings related to cutting functions.
l
Cutting Menu Screen
MENU
Cutting
>
width:1340mm
REMOTEMENU
TEST PRINT
CLEANING
LOCAL
>><<
Cutting
TPDETECT
>
CUTMODE
NORMAL
>
COPY
>
TOOLCHANGE
>
SETUPSUBMENU
>><<
Cutting
MAINTENANCE
>
>><<
Cutting Menu List
Item
Setting
*1
Details
TP DETECT - Enter the conditions of the printed register marks.
Detection ON/OFF Set this to ON to cut cutting data with register marks.
Shape Type 1/Type
2/Zero Margin
Select three types of register mark shapes.
"Register marks"(P. 98)
Size 5 to 40 mm Set the register mark length (B).
Line width
Register mark length (B)
"Standards for Register Mark Length and Line Width"(P. 99)
OFFSET X -5.00 to 5.00
mm
Change the position of the register mark origin. If the cut position
shifts in the same direction, change the position of the origin.
Mark: Type 1 Mark: Type 2
Plus X direction Plus X direction
Plus Y direction
Plus Y direction
Origin
Origin
• If “ERROR 37 MARK ORG” is displayed, change the layout by referring
to the following.
"Reading Range of Register Marks"(P. 100)
OFFSET Y -5.00 to 5.00
mm