Chapter 6 Maintenance
150
LED Glass Replacement
Replace with new LED glass if the ink hardens and the existing LED glass becomes dirty.
1
In LOCAL mode, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Head Maint.], then press the [ENTER] key.
• The carriage moves to the maintenance space.
3
Open the maintenance cover.
4
Remove the LED glass.
• Unclip the claw and slide to the side to remove.
• Be careful not to apply too much force when unclipping the claw. Disregarding this precaution may
result in breakage of the claw.
5
Insert new LED glass.
• Insert until it clicks into place. Confirm that the claw is engaged.
To Next Page
Loading...
