Chapter 6 Maintenance
147
6
Insert a new wiper.
7
Press the [ENTER] key once replacement is complete.
8
Close the front cover, then press the [ENTER] key.
• The wiper usage count is reset.
Cap Absorber Replacement
This product maintains a usage count. The “Replace Cap Absorber” message appears on the display when a
preset count is reached.
(This is supported in firmware version 2.5 and later)
If the cap absorber is very dirty or if ink drips on to the media, replace with a new cap absorber.
1
The “Replace Cap Absorber” message appears on the display.
2
In LOCAL mode, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
3
Select [Station] > [Carriage Out] > [Station Maint.], then press the [ENTER] key.
• The carriage moves over the platen.
• The cap absorber usage count is reset.
4
Turn off the power.
5
Open the front cover.
6
To Next Page
Loading...
