Chapter 2 Printing
74
2.10 Printing RIP Data
Check beforehand
• Was the head gap adjusted? "Adjusting Print Head Height"(P. 53)
• Were the pinch roller positions adjusted? "Adjusting the Pinch Roller Positions"(P. 54)
• Is media loaded? "Loading the Media"(P. 59)
• Was the pinch roller pressure adjusted? "Setting the Pressure and Number of Pinch Rollers to Use"(P. 67)
• For roll media, is the rear roll media free of sagging?
• When using the take-up unit, was the medium mounted on the core of the take-up unit? "Loading the Roll
Media"(P. 59)
Preparing RIP Data
The explanation here applies to MIMAKI RIP software (RasterLink).
• Prepare suitable image data for printing.
1
Launch RasterLink.
• Click the icon on the PC desktop.
2
Select the image data to print.
(1) Select [File] > [Open].
(2) Select the desired image data, then click [Open].
• If multiple printers are registered, select UCJV300 Series, 150 Series in “Printer name”.
To Next Page
Loading...
