MIMAKI UCJV300 Series - Investigating Cutting Failures and Adjusting Misalignment (Printing & Cutting)

Chapter 7 Troubleshooting
170
7
Check the following again.
• "Adjusting the Position of the Register Mark Sensor"(P. 168)
• If the buzzer does not sound four times, check the printed register mark conditions and contact
your local distributor, our sales office, or service center.
Investigating the Cause of Cutting Failures
1
In LOCAL mode, select [MENU] > [CUTTING], then press the [ENTER] key.
• The Cutting menu is displayed.
2
Select [MAINTENANCE] > [SAMPLE CUT], then press the [ENTER] key.
3
Select the sample data, then press the [ENTER] key.
• There are two sample types: "Cut" and "Logo".
Sample
Cut Logo
• If you select “Cut”, press the [ENTER] key to start cutting.
• If you select “Logo”, refer to the following:
(1) Press to specify the scaling factor (1 to 999 %).
(2) Press the [ENTER] key to start cutting
• The settings are retained even if [SETUP RESET] is selected.
l
Sample Cut Results
• Sample data can be cut properly, but not other data.
– There is a problem with the host PC.
• Sample data as well as other data cannot be cut properly.
– There is a problem with the printer. Increase the pressure in the ADJ-PRS OFFSET menu.
"Cutting Menu List"(P. 124)
Adjusting to Correct Misalignment Between Printing and Cutting
In the procedure described below, MIMAKI RIP software (RasterLink) is used to print a correction pattern.
When printing and cutting without register marks, correction is required for each resolution in the scan (Y)
direction. (The corrected value is saved for each resolution.) Print a pattern for each resolution, then input
the correction value.
1
Switch the machine to REMOTE mode.
2
Set the print conditions (profile/cut conditions) for the job you want to print in RasterLink.