2-5
2
2
2
5
6
Chapter 2 Basic Operation
Setting the Table Height
If the table height is changed, Media Thickness is also
changed.
1
Press the
(MENU)
key in LOCAL.
• HEAD HEIGHT MENU will be displayed.
2
Press to serect “TABLE
HEIGHT” , and press the key.
3
Press to set the table height,
and press the key.
Set value : 0.0 to 153.0mm
4
Press the key several times to
end the setting.
Changing origin
The default origin position can be changed by pressing
JOG keys [][][][].
1
Press the keys
in the local mode.
• The origin setting mode starts
• A red light pointer mark [] is projected on the
table or the media.
2
Move the light pointer mark by pressing
the keys.
• Move the light pointer mark to the position to set a
new origin.
3
Press the key when the printing
origin is determined.
• The origin is changed.
• The origin can also be changed from "ORIGIN
SETUP MENU". ( P.3-5)
• The height of the table is also fixed at the same
time. Adjust the height of the table by pressing the
[FUNC1] key (down), the [FUNC3] key (up) in
advance.
• The setting value for the origin set with the JOG
keys is cleared by cutting the power.
• The setting of the table height holds even if turning
off the power.
Changing with the JOG keys
SET ORIGIN
X= 0.0 Y= 0.0
TABLE HEIGHT
149.0
TABLE-UPVACUUM
TABLE-DOWN
Origin Position
(right and left)
Origin Position
(back and front)
Origin Position
(height)
To Next Page
Loading...
