MIMAKI UJF-7151 plus - Nozzle Check and Information Menus

3-29
Chapter 3 Setup
3
2
2
2
About NOZZLE CHECK MENU
Set operations concerning the nozzle missing detection function.
INFORMATION MENU table
Function name Set value Default Meaning
Printing Check ( P.3-31) ON / OFF OFF
Set this when you want to conduct nozzle check at the
beginning of online printing.
(ON)
Check
Interval
SET UP Job Job Conducts nozzle check for each file.
Interval 1 to 100 30 file Conducts nozzle check at each set number of files.
*1
*1. When the set length is reached during printing, nozzle check is conducted at the start of the next printing.
Action
CLEANING
SOFT / NORMAL
/ HARD
SOFT Sets the type of cleaning performed during recovery work.
RETRY
COUNT
0 to 3 0 Repeats the retry operation for the set number of times.
NOZZLE RECOVERY
(P.3-31)
ON / OFF OFF Set this when you want to conduct automatic nozzle recovery.
Judgement Condition
(P.3-31)
1 to 100 1
Sets how many missing nozzles are detected for “Nozzle
Missing” judgment to be made according to each color.
(Maximum 10 per 1 nozzle line)
*2
*2. Depending on the print conditions, nozzle recovery is not applied in some cases.
NOZZLE CHECK
Printing Check
OFF
Auto Nozzle Recovery
>
ON
Judgement Condtion
REMOTEMENU
TEST PRINT /
CLEANING
Local
XYZ
0.0 mm 0.0 mm 153.0 mm
MENU
MACHINE SETUP
>
> NOZZLE CHECK
>
INFORMATION
>><<
REMOTEMENU
TEST PRINT /
CLEANING
Local
XYZ
0.0 mm 0.0 mm 153.0 mm
 NCU MENUs at-a-glance
Press this to select
INFORMATION MENU, or to
switch to the previous screen.
Press this to switch to the
next screen.
Use these to select a
setting item.
Press this to confirm a
setting, etc.