MIMAKI UJF-7151 plus - Setting a KEY BUZZER; Set the Network

3-21
Chapter 3 Setup
3
2
2
2
Setting a KEY BUZZER
You can turn off the buzzer sound when pressing the key.
1
Press the
(MENU) (>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “KEY BUZZER” ,
and press the key.
3
Press to select a set value, and
press the key.
• Set value : ON/ OFF
4
Press the key several times to
end the setting.
Set the network
1
Press the
(MENU) (>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “NETWORK” ,
and press the key.
3
Press to select “CHECK IP
ADDRESS” , and press the key.
• The IP address currently used by this machine is
displayed.
• When you have finished the check, press the
[ENTER] key.
4
Press to select “CHECK MAC
ADDRESS” , and press the key.
• The MAC address currently used by this machine
is displayed.
• When you have finished the check, press the
[ENTER] key.
5
Press to select “DHCP” , and
press the key.
6
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• When it is ON, the IP address given by the DHCP
server is used.
7
Press to select “AutoIP”, and
press the key.
8
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
9
Press to select “IP ADDRESS” ,
and press the key.
10
Press to select a set value, and
press the key.
11
Press the key several times to
end the setting.
• When the key buzzer is set to "OFF", the buzzer
sound for errors, warnings, operation completion,
etc. cannot be shut off.
• After connecting with the network, it takes time until
the IP address is determined. If the IP address has
not been determined, “0.0.0.0” is displayed.
• To reflect network setting, once turn off the power
supply and turn it on again.