MIMAKI UJF-7151 plus - Setting of PRIORITY(UJF-7151 Plusii Only); Setting of PRIORITY(UJF-7151 Plusii Only)3-4

3-4
Chapter 3 Setup
Setting of PRIORITY(UJF-7151 plusII only)
Selects the priority from the settings on this machine
(PLOT) or the settings on a computer (HOST) about Head
Height.
1
Press the
(MENU)
key in LOCAL.
• HEAD HEIGHT MENU will be displayed.
2
Press to select “PRIORITY” , and
press the key.
3
Press to select a set value, and
press the key.
• Set value : HOST/PLOT
• If you select [HOST], "Change Height" will be
displayed. Proceed to Step 4. If you select
[PLOT] proceed to Step 5.
4
Press to select a set value, and
press the key.
• Set value : AUTO/MANUAL
• When AUTO is selected:
Whenever there is a height change from the
computer, the obstacle the obstacle check is
automatically redone.
• When MANUAL is selected:
Whenever there is a height change from the
computer, the display will ask if the height should
be applied or not.
5
Press the key several times to
end the setting.