Chapter 2 Basic Operation
2-6
Set the media in another method
You can lower the table to set media more easily.
1
Press the
(MENU)
to select the
“WORK SET” and press the key
in LOCAL.
• The table moves down.
2
Set media along the L-shaped mark (print
origin) on the right corner of the table.
• To change the printing origin, see the following
page. ( P.2-5 “Changing origin”)
• To use tools, set into the shaves (8.0 mm-deep)
on the corners of the table.
3
Press the key.
• The table moves up to the table height for
drawing.
About switching vacuum fan
The vacuum function to fix the media at printing
automatically starts.
Test printing
Make test printing in the specified direction to check
whether there is nozzle clogging or other printing failures
(such as wearing or missing).
1
Press the (
TEST PRINT/CLEANING)
in the local.
2
Press to select the
"TEST
PRINT
" and press the key.
3
Press to select the printing
direction, and press the key.
• When nozzle recovery is not set, test printing is
started in the selected direction.
• SCAN DIR: Draws in the scan (widthwise)
direction of the media.
FEED DIR: Draws in the feed (longwise) direction
of the media.
4
Test printing ends.
• The table moves to the front side, and then the
mode returns to the local.
• You can set the vacuum function operation. For
details, refer to P.3-13 “Setting of FAN MODE.”
• When you set the “Fan mode” of the setting mode
to “Manual”, switch ON/OFF by pressing the [SEL]
and [FUNC1].
• When you use white or clear ink, print on the clear
film to check.
Check before starting test printing
•Is media set? ( P.2-4) •Is origin point set?
( P.2-5)
• Is the table height appropriate? ( P.2-5)
• When nozzle recovery is set, press
[][] to set ON/ OFF and then press
the [ENTER] key.
ON : Draws with nozzle recovery ON.
OFF : Draws with nozzle recover OFF.
When FEED DIR
is selected
When SCAN DIR is selected
To Next Page
Loading...
