Chapter 5 Troubleshooting
5-4
Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message displayed in LOCAL
Message Cause Solution
OPERAT I ON
Incorrect operation is performed on the
operation panel.
• Operate this machine correctly.
!DATA REMA I N Unfinished printing data still remains. • Clear the data.
Message Cause Solution
INK NEAR END There is little ink in the supply unit.
• Check the ink bottle for the displayed
color. The ink in the bottle will end soon.
INK END
No ink remains in the ink bottle for the
displayed color.
• Replace the ink bottle and the ink IC chip
for the displayed color with new ones.
Expiration
The expiration date of an ink bottle has
passed.
(From the first day to the end of the month
following the expiration)
Expiration (1M)
The expiration date of an ink bottle has
passed.
(From the first day to the end of the month
following the month following the expiration)
Expiration (2M)
The expiration date of an ink bottle has
passed.
(3 months or more after expiration)
INK TYPE
The types of the installed ink bottle and the
ink IC chip are different.
• Check the types of the installed ink bottle
and the installed ink IC chip for the dis-
played color. Install the ink bottle and the
ink IC chip of the same type.
Color of INK
The color of the installed ink IC chip is
incorrect.
• Check if the displayed color matches the
colors of the installed ink bottle and
installed ink IC chip.
WRONG INK IC
The data error in the ink IC. • Insert the ink IC chip for the displayed
color.
When displaying again, contact your local
distributor, our sales office, or service
center.
NON INK IC
Cannot check the ink IC chip.
!WORK High
An obstacle is detected.
• An obstacle was detected. Lower the
table so that this warning disappears
WATER LACK
The level of water in the cooling water tank
is low.
• Refer to "Refill antifreeze mixed water" to
refill the cooling water.
!WS INKTANK CHK
The waste ink tank is full.
• Execute the station maintenance and
dispose of the ink in the waste ink tank.
CLEANING WIPER
It is time to clean the wiper or replace it
with a new one.
• Execute the station maintenance and
clean the wiper.
To Next Page
Loading...
