3-19
Chapter 3 Setup
3
2
2
2
MACHINE SETUP MENU table
Function name Set value Default Meaning
TIME ( P.3-20) +4h ~ -20h
Japan time
Time difference is corrected.
mm/ inch ( P.3-20) mm / inch mm A unit for displaying length is set.
KEY BUZZER ( P.3-20) ON / OFF ON A buzzer sound when keys are pressed is set.
NETWORK
(P.3-21)
Set the network.
Check IP Addr. The IP address currently used by this machine is displayed.
Check MAC Addr. The IP address currently used by this machine is displayed.
DHCP ON / OFF
When it is ON, the IP address given by the
DHCP server is used.
AutoIP ON / OFF
When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
IP Address
*1
Set the IP address used by this machine.
Default Gateway
*1
Set the default gateway used by this machine.
DNS Address
*1
Set the DNS server address used by this machine.
SubNet Mask
*1
Set the digit number of the subnet mask used by this machine.
EVENT MAIL
Mail Delivery
(P.3-22)
ON / OFF OFF
Set whether you send/ do not send the e-mail
when the set event occurs.
Select Event
(P.3-22)
Print Start
Event
ON / OFF OFF
Set whether you send/ do not send the e-mail at
the start of printing.
Print End Event ON / OFF OFF
Set whether you send/ do not send the e-mail at
the end of printing.
Error Event ON / OFF OFF
Set whether you send/ do not send the e-mail
when a error occurs.
Warning Event ON / OFF OFF
Set whether you send/ do not send the e-mail
when a warning occurs.
Other Event ON / OFF OFF
Set whether you send/ do not send the e-mail
when an event other than the above occurs.
Mail Address
(P.3-23)
Set the e-mail address to which
you send the event mail.
Alphanumeric characters and symbols (within 96
characters)
Message Subject
(P.3-23)
Set the characters to write in the
subject of the event mail.
Alphanumeric characters and symbols (within 8 characters)
Server Setup
(P.3-23)
SMTP Address Set the SMTP server.
SMTP Port No. Set the SMTP port number.
SENDER ADDRESS
Set the e-mail address to be used as the sender mail
address.
Authentication
POP before
SMTP
Set the SMTP server authentication method (SMTP
authentication).
SMTP
Authentication
OFF
User Name
*2
Set the user name used for the authentication.
Pass Word *2 Set the password used for the authentication.
POP3 Address
*3
Set the POP server.
APOP *3 Set ON/ OFF of APOP.
Transmit Test
(P.3-24)
Send the test e-mail.
Remote Control
*4
Permit DISABLE / ENABLE ENABLE
When ENABLE, remote control by Mimaki
Remote Access is allowed.
PIN code 0000-9999 0000
Set the authentication number for Mimaki
Remote Access.
KeyLife 5min-120min 30min
Set the time for Mimaki Remote Access to
automatically exit remote control when there is
no operation during remote control.
LANGUAGE ( P.3-26)
English / 日本語
English Displayed language is changed.
Ionizer ( P.3-26) ON / OFF OFF
Set the operation for the Ionizer (option).
To Next Page
Loading...
