MIMAKI UJF-7151 plus - Page 62

3-24
Chapter 3 Setup
12
Press to select “USER NAME” ,
and press the key.
13
Press to set User Name,
and press the key.
•Press [][][][] to set the user name to use
for the authentication.
• Set it with alphanumeric characters and symbols
within 30 characters.
14
Press to select “PASSWORD” ,
and press the key.
15
Press to set Pass Word,
and press the key.
•Press [][][][] to set the password to use for
the authentication.
• Set it with alphanumeric characters and symbols
within 15 characters.
• When you select [POP before SMTP] in the Step
9, set the items in the Step 14 to 17.
16
Press to select “POP3
ADDRESS” , and press the key.
17
Press to set POP3
Address, and press the key.
•Press [][][][] to set POP server.
• Input the POP server name.
• Set it with alphanumeric characters and symbols
within 40 characters.
18
Press to select “APOP” , and
press the key.
19
Press to set ON/ OFF, and press
the key.
20
Press the key several times to
end the setting.
Send a test e-mail
1
Press the
(MENU) (>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “EVENT MAIL” ,
and press the key.
3
Press the
(>>)
key.
• “TRANSMIT TEST EXECUTE” will be displayed.
4
Press the key.
• The sent result is displayed.
• If sending test e-mail has failed, an error code is
displayed.
Refer to the next page to solve the problem.
5
Press the key several times to
end the setting.
• On the password setting screen, you can
only check the value that you are
currently inputting.
TRANSM I T TEST
FAI LED: 12345 <en t >
Error code