3-11
Chapter 3 Setup
3
2
2
2
Setting of INK LAYERS
Set the number of times for over painting.
Finer drawing can be obtained by over painting.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press to select “INK LAYERS” ,
and press the key.
3
Press to select a set value, and
press the key.
• Set value : 1 to 9 times
4
Press the key several times to
end the setting.
Setting of REFRESH LEVEL
Set the refresh revel of the print head for preventing the
head clogging in a dusty environment or high head gap.
The larger level number indicates more frequent
refreshing times.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press to select “REFRESH” , and
press the key.
3
Press to select a set value, and
press the key.
• Set value : Level 0 to 3
4
Press the key several times to
end the setting.
Setting of PRIORITY
Select priority of setting of this machine or that of the
computer on the following items respectively.
Item : FEED COMP/INK LAYERS/LOGICAL SEEK/
REFRESH
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press to select “PRIORITY” , and
press the key.
3
Press to select a set value, and
press the key.
• Set value : ALL HOST/ALL PLOT/INDIVIDUAL
• If you select [INDIVIDUAL], proceed to Step 4. If
you select other items, proceed to Step 5.
4
Press to select a set value, and
press the key.
5
Press the key several times to
end the setting.
• To perform over painting, be sure to set "PLOT"
for INK LAYER in PRIORITY.
• When printing with setting the head gap to 2.1
mm or more, please set it to the level 2 or higher
to prevent nozzle clogging.
• When you give priority to the setting at the RIP
software side, make the setting value “Host”.
To Next Page
Loading...
