Chapter 3 Setup
3-2
About Head Height MENU
On SETUP MENU, you can set the print conditions to match the media you usually use.
Head Height MENU table
Function name
Set value
*1
*1. The underlined value is set at the time of purchase.
Outline
MEDIA THICKNESS
(P.3-3)
0.
0 to 153.0mm Setting the thickness of media.
HEAD GAP ( P.3-3) 1.5
to 4.0mm Setting the head gap.
TABLE HEIGHT ( P.2-5) 0.0 to 1
53.0mm Setting the height of the vacuum table.
GAP CHECK
( P.3-3) ON/ OFF/ INDIVIDUAL
Selecting an operation when obstacles are detected during
printing.
PRIORITY(UJF-7151 plusII only)
HOST/PLOT
Selects the priority from the settings on this machine
(PLOT) or the settings on a computer (HOST) about Head
Height.
MENU
WORK SET
>
>
HEAD HEIGHT
>
SET ORIGIN
SET UP
>
>
MAINTENANCE
>><<
HEAD HEIGHT
MEDIA THICKNESS
0.1mm
1.5mm
HEAD GAP
50mm
TABLE HEIGHT
ON
GAP CHECK
REMOTEMENU
TEST PRINT /
CLEANING
Local
XYZ
0.0
mm
0.0
mm
153.0
mm
REMOTEMENU
TEST PRINT /
CLEANING
Local
XYZ
0.0
mm
0.0
mm
153.0
mm
SETUP MENUs at-a-glance
Press this to select SETUP
MENU, or to switch to the
previous screen.
Press this to switch to the
next screen.
Use these to select
a setting item.en.
Press this to confirm
a setting, etc.
To Next Page
Loading...
