MIMAKI UJF-7151 plus - Chapter 3: Setup

This chapter
describes the various setting of this machine.
About Head Height MENU ........................... 3-2
Head Height MENU table........................... 3-2
Setting the Media Thickness ...................... 3-3
Setting the HEAD GAP .............................. 3-3
Gap check .................................................. 3-3
Setting of PRIORITY(UJF-7151 plusII only)3-4
About ORIGIN SETUP MENU ..................... 3-5
ORIGIN SETUP MENU table ..................... 3-5
Setting the X offset (remote), X offset (local)3-
6
Setting the Y offset (remote), Y offset (local)3-
6
Setting the Z origin ..................................... 3-6
Changing the origin using the JOG keys............ 3-6
About SETUP MENU ................................... 3-7
SETUP MENU table................................... 3-8
Setting of Media Correction........................ 3-9
Setting of LOGICAL SEEK......................... 3-9
Setting of INK LAYERS............................ 3-10
Setting of REFRESH LEVEL.................... 3-10
Setting of PRIORITY ................................ 3-10
Setting of UV MODE ................................ 3-11
Setting of WORK CHANGE ..................... 3-11
Setting of FAN MODE .............................. 3-12
Setting of AUTO CLEANING.................... 3-12
Setting of PRINT FLUSHING LEVEL....... 3-12
Setting of MAPS....................................... 3-13
Setting of the Misregistration adjust ......... 3-14
Setting of LT mode................................... 3-15
About MACHINE SETUP MENU................3-16
MACHINE SETUP MENU table................3-17
Setting Time..............................................3-18
Setting Unit (Temperature/ Length) .......... 3-18
Setting a KEY BUZZER............................3-19
Set the network.........................................3-19
Setting event mail function........................3-20
Setting of Remote control .........................3-24
Setting a LANGUAGE...............................3-24
Setting a Ionizer(Option)...........................3-24
Setting Option Jig set (Option)..................3-25
Setting of Work Change Position(MDL com-
mand)........................................................3-25
Setting reversal direction of JOG X ..........3-26
Setting the Auto Display Off......................3-26
Initializing the Settings..............................3-26
About NOZZLE CHECK MENU .................3-27
INFORMATION MENU table ....................3-27
Printing Check Flow..................................3-28
Printing Operations at “Nozzle Missing” Judg-
ment and Error Occurrence ......................3-28
Setting the Printing Check ........................3-29
Setting the NOZZLE RECOVERY ............3-29
Setting the Judgement Condition..............3-29
About INFORMATION MENU ....................3-30
INFORMATION MENU table ....................3-30
Displaying the Information ........................3-31
Chapter 3
Setup