MIMAKI UJF-7151 plus - Setting Printing Checks and Recovery

3-31
Chapter 3 Setup
3
2
2
2
Setting the Printing Check
Select ON when you want to conduct nozzle check at the
start of online printing.
1
Press the
(MENU)
(1 time)
key in LOCAL.
• NOZZLE CHECK MENU will be displayed.
2
Press to select “Printing Check”,
and then press the key.
3
Press to select ON, and then
press the key.
• The “Check Interval” setting screen will be
displayed.
• “Select OFF to not set nozzle check. Proceed to
Step 11.
4
Press the key.
5
Press to select setting item, and
then press the key.
Job: A nozzle check is conducted at the set
number of printing jobs.
6
Press to select setting value, and
then press the key.
SET UP: 1 to 100 Job
7
Press to select “Action”, and
then press the key.
• The “Action” setting screen will be displayed.
8
Press the key.
• “CLEANING” will be selected.
9
Press to select cleaning type,
and then press the key.
Setting value: SOFT/ NORMAL/ HARD
10
Press to select retry count, and
then press the key.
Setting value: 0 to 3
11
Press the key several times to
end the setting.
Setting the NOZZLE RECOVERY
Set this if you want to conduct automatic nozzle recovery
when nozzle missing is detected.
1
Press the
(MENU)
(1 time)
key in LOCAL.
• NOZZLE CHECK MENU will be displayed.
2
Press to select “NOZZLE
RECOVERY”, and then press the
key.
3
Press to select ON/OFF, and then
press the key.
4
Press the key several times to
end the setting.
Setting the Judgement Condition
Set the conditions for judging nozzle missing.
1
Press the
(MENU)
(1 time)
key in LOCAL.
• NOZZLE CHECK MENU will be displayed.
2
Press to select “Judgement
Condition”, and then press the
key.
3
Press the key to select a color.
4
Press to set the number of
nozzles for judgment, and then press the
key.
5
Press the key several times to
end the setting.
• The type of color changes depending on
the ink set.