MIMAKI UJF-7151 plus - Media Correction and Logic Settings

3-10
Chapter 3 Setup
Setting of Media Correction
A pattern for media correction is printed and a feeding
rate is corrected.
1
Set a media. ( P.2-4)
2
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
3
Press to select “FEED COMP.” ,
and press the key.
4
Press the key to print a correction
pattern.
5
Check the correction pattern and enter a
correction value.
• A screen for entering the correction value will be
displayed.
• Enter a correction value in "+":
The boundary between the three bands is
widened.
• Enter a correction value in "-":
The boundary between the three bands is
narrowed.
• When you change the correction value by “1”, the
width of the boundary changes by about 0.83μm.
6
Press the key.
• Print a correction pattern again and check it.
• When media correction is needed, perform the
operation in Step 5 to make correction.
7
Press the key several times to
end the setting.
Setting of LOGICAL SEEK
The head’s operation varies depending on the LOGICAL
SEEK settings, as shown in the figure below.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.key.
2
Press to select “LOGICAL SEEK”
, and press the key.
3
Press to select a set value, and
press the key.
• Set value : ON / OFF
4
Press the key several times to
end the setting.
• Three bands are printed in the correction pattern.
• Make adjustment so that an even color density is
obtained in the boundary between the three
bands.
Third band
First band
Table advance direction
Second band
UNI-DIRECTIONAL
Movement of heads when LOGICAL seek is OFF
Movement of heads when LOGICAL seek is ON
UNI-DIRECTIONAL
Media
Red arrow :
Movement of head
Print erea
Red arrow :
Movement of head
Print erea
Media