3-15
1
2
3
4
5
6
Chapter 3 Setup
Setting of the Misregistration adjust
It is used when the mis-registration occurs at printing the
color/spot color version.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press the
(<<)
.
3
Press to select “Misregistration
adjust” , and press the key.
4
Press to choose “feed direction”
, “scan direction” or “reverse print”.
Feed direction : correct the mis-registration of
feed direction
Scan direction : correct the mis-registration of
scan direction
Reverse print : correct the mis-registration of
feed direction in the forward print
(color to spot color) and reverse
print (spot color to color)
5
Press the key.
• If you select the feed direction or scan direction in
Step 4, proceed to Step 6.
• If you select the reverse print in Step 4, enter the
deviation amount of feed direction of forward print
and reverse print in 0.01mm unit.(See figure
below).
When the result of reverse
print is
• above against the forward
print > enter the “minus”
value.
• lower against the forward
print > enter the “plus”
value.
• When done, proceed to
step 10.
6
Press to select the resolution to
adjust , and press the key.
Feed direction: 600dpi/900dpi/1200dpi
Scan direction：600dpi/1200dpi
7
Press to select “Print” or “Set
Adjust” , and press the key.
print: print the adjustment pattern.
*Use transparent media with the A4
landscape size or more in Y direction.
Set Adjust: Enter the correction value and proceed
to Step 10.
8
Print the adjustment pattern.
• The straight line of the central pattern (correction
value is 0) is a little longer than others both for the
feed direction and scan direction.
9
Check the adjustment pattern (see figure
below), and enter the adjustment value.
• Input screen of the correction value is displayed.
• Choose the number that two lines are overlapped
to clean in the adjustment pattern and enter to the
correction value.
In the case of the figure below, for the best pattern
is "-2", enter "-2" in correction value.
10
Press the key several times to
end the setting.
Adjustment pattern
Reverse print
Forward print
Gap
㻙㻤
㻙㻞 㻙㻝 㻗㻝 㻗㻞 㻗㻤
㻜
䞉䞉 䞉䞉
㻙㻤
㻙㻞 㻙㻝 㻗㻝 㻗㻞 㻗㻤
㻜
䞉䞉 䞉䞉
Feed direction
Scan direction
- direction
+ direction
- direction
+ direction
center
center
To Next Page
Loading...
