3-16
Chapter 3 Setup
Setting of LT mode
To enable LT mode, set it to ON.
Set LT mpde when you need more flexibility than the
default UV mode print.
Since UV light intensity adjustment is performed, check
the print performance (stickiness, odor etc.) before using
the LT mode.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press the
(<<)
.
3
Press to select “LT mode” , and
press the key.
4
Press to select a set value, and
press the key.
• Set value :ON / OFF
• When "ON", the LT mode is enabled under the
following printing conditions.
5
Press the key several times to
end the setting.
Ink type
Printing
condition
Resolution
Pass Media
LUS120
Color
layers
1
layer
600 x 600 8 pass
Artificial
leather
• If the printing conditions are different
from the above, LT mode will not be
valid even if LT mode is ON.
• When printing in LT mode, "LT" is
displayed on the screen during
printing.
To Next Page
Loading...
