BeneVision N Series Patient Monitor Operator’s Manual 30 - 1
30 Monitoring NMT from TOF-Watch SX Monitor
30.1 NMT Introduction
This monitor can connect a Organon TOF-Watch SX monitor for NMT(neuromuscular transmission) monitoring.
This monitor can display, store and review measurements from TOF-Watch SX monitor, as well as present related
alarms. On this monitor, you can separately set the level of NMT related alarms and switch on or off alarm
recording; you can also view TOF-Watch SX monitor settings of alarm limits and alarm switch.
30.2 NMT Safety Information
• TOF-Watch SX monitor is manufactured by Organon. This company provides the technology for
measuring NMT parameters. We only provide the connection between this monitor and TOF-Watch
SX monitor.
• If you have any doubts about the operation and maintenance of the TOF-Watch SX monitor, please
see TOF-Watch SX monitor operator’s manual or directly contact Organon.
• Fully observe TOF-Watch SX monitor operator’s manual to make settings and to connect the monitor
with a patient.
30.3 Connecting a TOF-Watch SX monitor
The TOF-Watch SX monitor connects with BeneLink module through an ID adapter, see the figure below.
To connect the TOF-Watch SX monitor, follow this procedure:
1. Insert a BeneLink module into the module rack.
2. Connect the ID adapter that matches the TOF-Watch SX monitor to the BeneLink module with an RJ45
connecting cable.
3. Connect the ID adapter to the TOF-Watch SX interface with Mindray type C serial port adapting cable.
(1) BeneLink Module (2) Label
(3) RJ45 connecting cable (4) ID Adapter
(5) Type C serial port adapting cable & TOF-Watch SX interface cable
(6) TOF-Watch SX monitor
To Next Page
Loading...
Need help?
General
