3-90 TM80 Telemetry Monitor Service Manual
address.
2 IGMP snooping If CMS accepts TM80 use multicast,
enable IGMP snooping
Nice to meet
3 Multicast The multicast function is enabled.
Otherwise, the TM80 can only
connect to the CMS in unicast
mode.
The
requirement
must be met.
4 Beacon & DTIM AP DTIM = 1, Beacon = 100ms The
requirement
must be met.
5 AP data rate Close the data rate of
1Mbps,2Mbps,5.5Mbps in
802.11b
Nice to meet
6 QOS The switch or router must support
QoS and the QoS level of TM80's
subnet must be set to the highest
level.
Nice to meet
EAP requirements
1 EAP requirements Refer to 3.2.1.4 for detail The
requirement
must be met.
To Next Page
Loading...
Need help?
General
