Mindray BeneVision TM80 Service Manual

TM80 Telemetry Monitor Service Manual 3-89
locate the TM80 may occur.
4 AP channel width If the AP supports 802.11n/ac, set
the channel width to 20Mhz, don’t
use HT40 or even HT80.
The
requirement
must be met.
5 Dedicated VLAN
The TM80 needs to work on a
dedicated VLAN.
Using VLAN can minimize Broadcast
or multicast data which can affect
TM80 stability.
The
requirement
must be met.
Network service and VLAN
1 Port UDP ports 5500 and 6678 are
enabled.
TCP ports 6587 and 7779 are
enabled.
The
requirement
must be met.
2 VLAN bandwidth The planned bandwidth of TM80
must be larger than N*100 kbps (N
is the number of installed TM80
products).
For example, if 10 TM80 products
are working at the same time, the
VLAN needs to meet the bandwidth
of 1000 kbps.
The
requirement
must be met.
4 Network
continuity
In the coverage area of TM80, the
network belongs to the same
WLAN. All APs use the same SSID
and encryption mode.
The
requirement
must be met.
Important settings
1 DHCP The DHCP server reserves a
sufficient number of IP addresses
for the telemetry VLAN to ensure
that the TM80 can obtain an IP
The
requirement
must be met.

Mindray BeneVision TM80 Specifications

General

Brand	Mindray
Model	BeneVision TM80
Category	Monitor
Language	English