Mindray BeneVision TM80 Service Manual

TM80 Telemetry Monitor Service Manual 3-101
number of IP
addresses for the
telemetry VLAN to
ensure that the TM80
can obtain an IP
address.
2 IGMP
snoopin
g
If CMS accepts TM80
use multicast, enable
IGMP snooping
Check with hospital IT if this
requirement is met or not.
3 Multicast The multicast
function is enabled.
Otherwise, the TM80
can only connect to
the CMS in unicast
mode.
Check with hospital IT if this
requirement is met or not.
4 Beacon
& DTIM
AP DTIM = 1, Beacon
= 100ms
Check with hospital IT if this
requirement is met or not.
5 AP data
rate
Close the data rate of
1Mbps,2Mbps,5.5Mb
ps in 802.11b
Check with hospital IT if this
requirement is met or not.
6 QOS The switch or router
must support QoS
and the QoS level of
TM80's subnet must
be set to the highest
level.
Check with hospital IT if this
requirement is met or not.
EAP requirements
1 EAP
requirem
ents
Refer to 3.2.1.4 for
detail
Check with hospital IT if this
requirement is met or not.

Mindray BeneVision TM80 Specifications

General

Brand	Mindray
Model	BeneVision TM80
Category	Monitor
Language	English