TM80 Telemetry Monitor Service Manual 3-19
TM80s are working at the same time, VLAN bandwidth must be larger than
1Mbps, better to be greater than 2Mbps.
Network continuity
TM80 needs to roam across Aps. TM80 can’t roam across different IP subnet and
different SSID;
3.2.2.2 Some Important Settings of Network Device
No. Item Requirements of the TM80 Description
1 DHCP The DHCP server reserves a sufficient
number of IP addresses for the
telemetry VLAN to ensure that the TM80
can obtain an IP address.
The requirement
must be met.
2 IGMP
snooping
If CMS accepts TM80, use multicast,
enable IGMP snooping.
Nice to meet
3 Multicast The multicast function is enabled.
Otherwise, the TM80 can only connect
to the CMS in unicast mode.
The requirement
must be met.
4 Beacon &
DTIM
AP DTIM = 1, Beacon = 100ms The requirement
must be met.
5 AP data
rate
Close the data rate of
1Mbps,2Mbps,5.5Mbps in 802.11b
Nice to meet
6 QOS The switch or router must support QoS
and the QoS level of TM80's subnet
must be set to the highest level.
Nice to meet
To Next Page
Loading...
Need help?
General
