TM80 Telemetry Monitor Service Manual 3-29
3.3.4.1 General Settings
1. Choose CONTROLLER→General. The configuration page is displayed.
2. Perform the following configuration on the page.
Broadcast Forwarding=Enable
The figure below shows the specific General configuration.
3. Click Apply and Save Configuration.
3.3.4.2 Multicast Settings
1. Choose CONTROLLER→Multicast. The configuration page is displayed.
2. Perform the following configuration on the page.
Enable Global Multicast Mode=Enabled
Enable IGMP Snooping=Enabled
To Next Page
Loading...
