3-34 TM80 Telemetry Monitor Service Manual
Coverage Settings
On the page, enable coverage hole detection and set the detection standard.
1. Choose WIRELESS→802.11b/g/n→RRM→Coverage. The configuration
page is displayed.
2. Perform the following configuration on the page.
Enable Coverage Hole Detection=Enabled
The figure below shows the specific Coverage configuration.
3. Click Apply and Save Configuration.
3.3.5.2 Setting Access Points (2.4G)
1. Choose WIRELESS→Access Point→Radio→802.11b/g/n. The
configuration page is displayed.
2. Perform the following configuration on the page.
Admin Status=Enabled
RF Channel Assignment(Assignment method)=Global
Tx Power Level Assignment(Assignment method)=Global
To Next Page
Loading...
