FrameMaker Ver5.5E(PC) Di251/Di351 SWITCHES ON PWBs/TECH. REP. SETTINGS
05.03.01
S-19
2. Printer
• Make the necessary adjustments of the printer (engine).
Touch Panel
Display
Setting (The default is ).
Edge Erase Set the erase width on the leading, trailing, right, and left edge of the
image.
Loop Adjustment Set the length of the loop to be formed in paper before the Synchro-
nizing Rollers
Image Density Set the image density for the printer. The value set for this function
becomes the central value of “
Priority Density” of User’s Choice.
ATDC Sensor
Gain
Current: Shows the current ATDC control voltage.
Set: Set the ATDC control voltage.
Note:
• Be sure to record this value when I/C has been changed.
VG Adjust Vary the Vg voltage to set the desired image density.
Highlighted
0to5mm( )
4mm
-5 to +5 mm ( )
0mm
-3............................................. ............................................+3
Lighter Darker
0
123....................................... .......................................186
T/C Greater T/C Smaller
155
-2............................................. ............................................+2
Lighter Darker
0
To Next Page
Loading...
