102
4.2.2 Group function
By specifying transient transmission target stations as a group, data can be sent to all stations of the same group No.
Set the group No. of the CC-Link IE Controller Network module in the network parameters of a programming tool.
( Page 180, Section 6.2)
● One network can be divided into up to 32 groups.
● In the case of transient transmission using group specification, whether the instruction has reached the target or not
cannot be confirmed.
Group No.1
Group No.1 Group No.1
Network No.1
Station No.1 Station No.2 Station No.3
Station No.6 Station No.5 Station No.4
To Next Page
Loading...
