225
CHAPTER 6 PARAMETER SETTING
6
6.6 Interrupt Settings
6.6 Interrupt Settings
Set the conditions for sending an interrupt request to the CPU module. ( Page 135, Section 4.5)
Up to 16 interrupt conditions can be set.
1. Configure the network setting. ( Page 180, Section 6.2)
2. Open the setting window in the programming tool.
Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET]
button
3. Configure settings with reference to the description below.
4. Click the button.
To Next Page
Loading...
