Mitsubishi Electric MELSEC-Q Series - Default Settings

221
CHAPTER 6 PARAMETER SETTING
6
6.5 Refresh Parameters 6.5.3 Default settings
6.5.3 Default settings
Refresh parameters can be set properly according to the number of modules and the mounted positions given in Page
222, Section 6.5.3 (2).
(1) Setting method
By clicking the button on the refresh parameters window for each module, refresh parameters are set
based on the number of modules and the position of the module.
Ex.
When two modules are mounted
• Refresh parameters of module 1
• Refresh parameters of module 2