196
6.3.3 Shared group
For a Universal model QCPU, set the stations that share their cyclic data to the same shared group No. (Setting range:
None or 1 to 120, Default: None)
This setting is common to "LB/LW Setting(1)", "LB/LW Setting(2)" and "LX/LY Setting(1)", and "LX/LY Setting(2)".
( Page 83, Section 4.1.8)
(1) Directly entering a shared group No.
Directly enter a shared group No. in the shared group area of [Assignment the CC IE Control Network Range].
(2) Using the shared group setting
The following is a procedure for setting a shared group number 1 with the shared group setting.
In "Station List" in the "CC IE Control Shared Group Setting" window, the cells for the stations selected for the shared group
are colored.
1. Clicking the button in "Assignment the CC IE
Control Network Range" will display the "CC IE Control
Shared Group Setting" window.
2. In the "Shared Group" column, select "(Edit Shared Group
Specification)".
3. In the "Shared Group Setting" window displayed, enter "1"
and click the button.

4. In the "Shared Group Setting (Shared Group 1)" window,
select a station No. to be set for the shared group No.1 to
add to "Registered Station No." and click the
button.
5. In the "Shared Group" column of "Assignment the CC IE
Control Network Range", the shared group No.1 is set.
To set a new shared group, repeat the above steps 2. to 4.

6. To edit an existing shared group, select the shared group
No. in "Shared Group" and click on button to
perform the operation of the step 4
To Next Page
Loading...
