Mitsubishi Electric MELSEC-Q Series - Example of Communications Using the IP Packet Transfer Function

118
4.3.6 Example of communications using the IP packet transfer
function
The following system configuration is used to explain an example of communications.
(1) Setting in the CPU module 1 and control station (station number 1)
1. Set the IP address in the CPU module 1.
Project window [Parameter] [PLC Parameter] "Built-in Ethernet Port Setting"
Ethernet device
(request source device)
192.168.1.1
: Route through which IP packets are passed (Routing parameters must be set.)
Network No.1
Network No.10
CPU module 1: 192.168.1.10
Control station
(Station No.1)
: 192.168.2.1
CPU module 2: 192.168.10.10
Normal station
(Station No.2)
: 192.168.2.2
Network No.2
Ethernet device
(request destination device)
192.168.10.1