Mitsubishi Electric MELSEC-Q Series - Page 121

119
CHAPTER 4 FUNCTIONS
4
4.3 IP Packet Transfer Function 4.3.6 Example of communications using the IP packet transfer function
2. Configure the IP packet transfer setting in the CPU module 1.
Project window [Parameter] [PLC Parameter] "Built-in Ethernet Port Setting"
button
3. Set the routing parameters in the CPU module 1.
Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET]
button
4. Set the IP address in the control station (station number 1).
Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET]
button
5. Write the set parameters to the CPU module 1. Then reset the CPU module 1 or power off and on
the system.
[Online] [Write to PLC]
or Power OFF ON
RESET