541
CHAPTER 10 TROUBLESHOOTING
10
10.4 Checking the Error Description with the CC IE Control Diagnostics
10.4 Checking the Error Description with the CC IE Control
Diagnostics
This section describes the method of checking the error description with the CC IE Control diagnostics.
Monitoring timeout
Parameter unreceived
Own station No. is out of range
Own station is set as reserved station
Own station No. duplication
Control station duplication
Illegal network No.
CPU module stop error
CPU module power stop error
External power not supplied
Control station duplication and own station No.
duplication
Cable disconnection or line being established
Cable insertion error
Check network information display.
Select the station to which the faulty cable is
connected, and check the error details.
Connect Programming tool to the disconnected station,
and start the CC IE Control diagnostics.
Select the faulty station and check the error details.
Occurred
Yes
Yes
Has communication error occurred?
Is there any faulty station?
Is there any disconnected station?
(Black)
No
Not occurred
No
Start
End
Page 543, Section 10.4.1
Page 545, Section 10.4.2
Page 547, Section 10.4.3
Page 548, Section 10.4.4
Page 551, Section 10.4.6
Page 553, Section 10.4.7
Page 556, Section 10.4.8
Page 559, Section 10.4.9
Page 561, Section 10.4.10
Page 549, Section 10.4.5
Page 563, Section 10.4.11
Page 528, Section 10.3.1
Page 565, Section 10.4.12
Page 566, Section 10.4.13
To Next Page
Loading...
