180
.
6.2 Network Settings
Make settings for configuring the network.
1. Open the "MELSECNET/CC IE/Ethernet Module Configuration" window in the programming tool.
Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET]
2. Configure settings with reference to the description below.
3. Click the button.
Item Description
Network Type Select the station type of the CC-Link IE Controller Network module.
Starting I/O No. Set the start I/O number of the CC-Link IE Controller Network module in 16-point units.
Network No.
Set a network No. of the network to which the CC-Link IE Controller Network module is
connected.
Total Stations
When a control station is selected in "Network Type", set the total number of stations in
one network.
Group No. Set a group No. for performing transient transmission by group specification.
Station No. Set a station No. of the CC-Link IE Controller Network module.
Mode Select an operation mode of the CC-Link IE Controller Network module.
Station No. setting method For Universal model QCPUs, select how to set station Nos. of normal stations.
To Next Page
Loading...
