Mitsubishi Electric MELSEC-Q Series - Page 181

179
CHAPTER 6 PARAMETER SETTING
6
6.1 Parameter List
(2) Parameter list for normal stations
: Setting required, : Set it if required, ×: Setting not allowed
*1 A default value has been set. Change it if necessary.
1) Safety CPU
2) Basic model QCPU
3) High Performance model QCPU
4) Process CPU
5) Redundant CPU
6) Universal model QCPU
Item Description
CPU module
Reference
section
1) 2) 3) 4) 5) 6)
Network
setting
Network Type
Select the station type of the CC-Link IE Controller
Network module.
Page 180,
Section 6.2
Starting I/O No.
Set the start I/O number of the CC-Link IE Controller
Network module in 16-point units.
Network No.
Set a network No. of the network to which the CC-
Link IE Controller Network module is connected.
Total Stations Set the total number of stations in one network. × ×××××
Group No.
Set a group No. for performing transient
transmission by group specification.
*1 *1 *1 *1 *1 *1
Station No.
Set a station No. of the CC-Link IE Controller
Network module.
Mode
Select an operation mode of the CC-Link IE
Controller Network module.
Station No. setting
method
For Universal model QCPUs, select how to set
station Nos. of normal stations.
×××××
Refresh Parameters
Set the range of the transfer between the link
devices of the CC-Link IE Controller Network
module and the CPU module devices.
Page 204,
Section 6.5
Interrupt Settings
Set the conditions for sending an interrupt request to
the CPU module.
×
Page 225,
Section 6.6
Redundant Settings
For a Redundant CPU, set the operation mode of
the CC-Link IE Controller Network module on
system B.
×××× ×
Page 231,
Section 6.7
Interlink Transmission Parameters
Set the link device transfer range between network
modules.
××
Page 232,
Section 6.8
Routing Parameters
Set a relay station in the own network to transmit
data to another network.
Page 238,
Section 6.9