178
: Setting required, : Set it if required, ×: Setting not allowed
*1 A default value has been set. Change it if necessary.
*2 CPU modules that can be used differ depending on the connection path. ( Page 107, Section 4.3.1)
Network
Range
Assignment
Pairing
If the network contains a redundant system, set a
combination of stations of system A and system B.
××
Page 199,
Section 6.3.4
Specify Reserved
Station
Set reserved station(s).
Page 200,
Section 6.3.5
Supplementary
Setting
Set the constant link scan time, block data assurance per
station, punctuality assurance, and the maximum number
of transient transmissions for one station.
*1 *1 *1 *1
Page 201,
Section 6.3.6
Network Operation Settings
The IP address of the CC-Link IE Controller Network
module is set to communicate data with Ethernet devices
over CC-Link IE Controller Network.
×××
*2
Page 203,
Section 6.4
Refresh Parameters
Set the range of the transfer between the link devices of
the CC-Link IE Controller Network module and the CPU
module devices.
Page 204,
Section 6.5
Interrupt Settings
Set the conditions for sending an interrupt request to the
CPU module.
Page 225,
Section 6.6
Redundant Settings
For a Redundant CPU, set the operation mode of the CC-
Link IE Controller Network module on system B.
×× ×
Page 231,
Section 6.7
Interlink Transmission
Parameters
Set the link device transfer range between network
modules.
Page 232,
Section 6.8
Routing Parameters
Set a relay station in the own network to transmit data to
another network.
Page 238,
Section 6.9
Item Description
CPU module
Reference
section
1) 2) 3) 4) 5) 6)
To Next Page
Loading...
