231
CHAPTER 6 PARAMETER SETTING
6
6.7 Redundant Settings
6.7 Redundant Settings
For Redundant CPUs, set the operation mode of the CC-Link IE Controller Network module on system B. ( Page
138, Section 4.7)
1. Configure the network setting. ( Page 180, Section 6.2)
2. Open the "Redundant settings" window in the programming tool.
Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET]
button
3. Configure settings with reference to the description below.
4. Click the button.
Item Description
Network type
Displays the station type of the CC-Link IE Controller Network module on system B. (Same
as system A)
Start I/O No.
Displays the start I/O No. of the CC-Link IE Controller Network module on system B in units
of 16 points. (Same as system A)
Station No. (System A) Displays the station No. of the CC-Link IE Controller Network module on system A.
Mode (System A) Displays the operation mode of the CC-Link IE Controller Network module on system A.
Station No. (System B)
Displays the station No. of the CC-Link IE Controller Network module on system B.
Station No. of system B is set as system A's station No. +1.
Mode (System B)
Select an operation mode for the CC-Link IE Controller Network module on system B.
( Page 182, Section 6.2 (7))
To Next Page
Loading...
