Mitsubishi Electric MELSEC-Q Series - Page 161

159
CHAPTER 5 PREPARATION AND SETUP
5
5.4 Testing the CC-Link IE Controller Network Module 5.4.2 Self-loopback test
(c) Setting network parameters in the programming tool
1. Set the mode of the system A to the online mode.
Set the network parameters in the programming tool as shown below.
2. Set the mode of the system B to the self-loopback test.
Select "Self-Loopback Test" for "Mode (System B)" in the "Redundant Setting" window of the network
parameter of the programming tool.
3. Connect the programming tool to the system B CPU module and write the parameters to the
module.